Tu sei qui: Portale → Forum → KAM Forum → Control / Software → Problem with HolzHer 1317 → Re: Problem with HolzHer 1317
Navigation
Accedi


Hai dimenticato la tua password?
Nuovo collaboratore?
 
Register Login
Re: Problem with HolzHer 1317
Discussion Icon by Pero Eric at 20/04/2010 21:47

I have problem with temparature paste(glue)...
Only 0˙.
No errors no nothing.
I have a flash card. How i can flashing this machine, i wanna steps for flashing program with flash card. Can help me sombody.

Discussion Icon by Robert Klampfl at 21/04/2010 10:40

Hello Mr. Pero Eric.

I don't think you have success, with flashing your machine.

Maybe your temperature sensor is broken. Try to switch off the machine, disconnect the two sensors from Modul "GRM-A1" connector X17, pin 1,2,3,4
and restart the machine. If the temperature on your panel showing about 500°C, the control is ok and you have an broken sensor. A normal electrician can replace it. Pleas call your dealer to get a spare part.

If the controller also shows 0°C, you have a Problem with your modul "GRM-A1". In this case you need a service technician to fix this problem.

This solution possibility is only relevant, if there was no changes in closed menu for service technician before !!

With best regards
Robert Klampfl

Posts per page